Monday, May 21, 2012

On why it's best not to perform a factory reset on an Anytone AT-5555 unless you have a programming lead!

I mentioned in a post over the weekend that a couple of channels on the Anytone 10m rig were showing a slight discrepancy between transmit and receive when no clarifier was switched in.

I thought perhaps a factory reset might do the trick.

This morning, as I had a few moments before the train arrived, I performed the reset after I had parked up in the station car park.

With a loud beep the display changed to 25.615MHz! Quite a reset then, and the segments that had been programmed were lost! Just the lower bit of 28MHz was accessible!

Happily, you may recall that some months ago, I purchased the programming lead for the AT-5555. And even more surprisingly, I had backed up the configuration of the rig onto my laptop.

So, this evening saw me out on the drive with the laptop, the rig open and the programming lead. It's all back as it should be (I think). Though I didn't check yet whether those two channels were fixed.

For a change, it was quite interesting to listen to the activity on 27.555 as I drove home.

3 comments:

Anonymous said...

Hi There Ive just bought one of these amazing radios and the tx/rx freqs seem a bit off..I have the factory menu details to sort this if you want it?
73 Pete

Tim said...

Hi Pete! That's interesting! Yes please.

The factory reset does seem to have done the trick as far as I can tell.

Tim

Rui Simas said...

Can You email me this? because my radio don't let me to transmit says I have high swr and I can't transmit.

Thank you

LinkWithin

Related Posts with Thumbnails